This shifter fits the Jeep CJ transfer case that has the stock shifter mounted about 7” in front of the transfer case, and a straight shift pattern, typicly a 4-speed application. Does not fit J series, Wagoneer, Cherokee, Commando / Jeepster. Allows independent operation of front and rear drive. (completely independent with removal of internal shift interlock pills) Stainless steel twin-stick shifter Made for the Dana Jeep CJ Dana-20 transfer case This transfer case shifter is made specifically to replace the stock shifter. BEWARE OF ONE SIZE FITS ALL shifters, there are 7 different configurations of Jeep D-20 cases / shifter combinations, unless you want to cut new holes in your floor, make sure you get a shifter that is built for your setup. Our shifters mount to your stock mounting bracket eliminating most of the locating issues with custom shifters. These shifters are designed to be rock-solid, you won't find any ny-lock nuts that are not designed for heat. We use only, all metal, mechanical self-locking hardware. This shifter comes with installation / adjustment instructions, boot, stainless steel trim ring, shift pattern decal, and even stainless steel screws to finish it off! Note: Not all installations / applications are the same, a little floor trimming or shifter adjustment might be necessary. MADE IN THE U.S.A. It offers short throw shifting, and rock solid feel due to the heavy stainless stock used to construct the shifter. This shifter comes with adjustable linkage made from stainless threaded rod, and quality metal rod ends.