|
We have documented with photos the installation steps for the harware on a Dana 44 Knuckle.
|
Parts Mike custom made Dana 44 knuckle with hardware and ball joints ready to be installed.
|
|
Install the spindle studs from the backside. You can also install the steering stop bolts and nuts at this time. |
|
Knuckle with spindle studs installed. Now it is time to install the ball joints.
The ball joint with the hole is the top one. The hole will be used for a cotter pin. |
|
Install the bottom ball joint first. The ball joints are pressed in from the top of the knuckle. |
|
Lower ball joint installed |
|
It's now time to install the snap ring on the lower ball joint. |
|
Snap ring installed on lower ball joint. |
|
Knuckle with both ball joints installed. The top ball joint does not use a snap ring like the lower ball joint. |
|
The high steer studs use a different thread on each end. The short thread is the
end that goes into the knuckle. |
|
The short thread, or dot side, on a stock GM stud, goes in the knuckle. |
|
High steer studs installed in knuckle. |
|
Completed knuckle ready for installation on the axle housing. |
|
|
Last Updated on Friday, 08 January 2010 13:24 |
